Side Rail for P90

We created this because we thought, It would be easier to press the flashlight switch if there were rails near the grip!

This is a rail kit that attaches by removing the resin parts of the left and right cocking handles.
Split the upper receiver and remove the resin part of the cocking handle with a star wrench.
Insert this product into the cocking lever from the front, align the screw positions, reattach the removed screws on both sides, and reassemble the upper receiver to complete.
When assembling, insert the rear protrusion into the gap of the lower receiver.

- Greatly increased expandability!
- Lights fit compactly, allowing you to press the switch while gripping!
- Lights are closer to the line of sight, making aiming easier!
- The long rail also accommodates longer flashlights better!
- The appearance becomes slightly more modern.

■Notes
This is not a difficult task, but the insertion is a bit tight.
If the screw holes do not align, you may need to tap it lightly or shave a little from the inside.
Please refrain from purchasing if you are unable to perform modifications yourself.
Simulated cocking will no longer be possible.
Also, there will be some wobble, so it is not ideal for sights.
This is a personally produced product using a 3D printer, so there may be some imperfections.
While there have been no complaints so far, please be aware of this in advance.
It is made of carbon fiber resin and is quite durable, but it may deform at temperatures above 60°C, so please be careful.
We offer a two-week warranty against breakage.